abandonment001009.jpg
abandonment001001.jpg
abandonment001002.jpg
abandonment001010.jpg
abandonment001005.jpg
abandonment001004.jpg
abandonment001013.gif
abandonment001003.jpg abandonment001006.jpg
Click on a link below.
Viable Alternative to Removal?
abandonment001014.jpg abandonment001015.jpg
Basic Facts
Misconceptions
What You and Your Home Inspector Should
Know and Look For
abandonment001007.jpg abandonment001008.jpg
Financial
Assistance
Tank Removal
This is why you should choose Sensible Solutions to remove/abandon the UST. The above photographs show what is probably the first State-approved removal with contaminated soil excavation and in-place abandonment of a leaking UST.
The Problem
The 560-gallon UST was located beneath the corner of an addition to the house. The tank had leaked fuel oil into the soils at the end not located beneath the house. Because the leakage was located on a property where the home owner obtained drinking water from a supply well, the State wanted the soils removed. But, the entire removal of the UST would undermine the corner foundation of the brick house, likely resulting in severe damage to the foundation and brickwork. Therefore, removal of the entire UST was deemed to be too risky.
We very likely have the
SOLUTION
to your
PROBLEM
UST
The Solution
Sensible Solutions proposed, obtained approval from the State, and implemented the partial removal of the UST with in-place abandonment of the section remaining beneath the house. The tank end was uncovered, and an access hole was cut in the end to allow the fluids to be removed and the interior pressure-washed clean. The clean soils surrounding the UST were carefully removed for later use as backfill. Care was taken to not disturb (loosen) the section of tank remaining beneath the house. The exposed half of the tank was cut off. Once the contaminated soils were excavated (successfully), a sheet of plywood was placed over the open end of the tank to hold back the dirt backfill. Then, flowable fill (sand/cement slurry) was unloaded into the tank section to completely fill the void and ensure the support of the foundation for years to come.
Typical In-Place Abandonment
A normal in-place abandonment involves uncovering an approximately 2-foot square area above one end of the UST. The tank is then cut open, cleaned out, and filled as shown above. The dirt and sod are then put back in place, leaving very little evidence that any work was performed. This is Sensible Solutions preferred method of UST closure. And, it costs less than removal (in most cases).
Click Here
for More Info.
on Proper
Abandonment
abandonment001011.jpg
abandonment001012.jpg
336-263-0965
P.O.Box 5294,Chapel Hill,NC 27514-5003